Welcome. yours is only 60 sailnumbers away from mine! With any luck, they may have been set up the same.
Metal parts on my boat:
1 bronze CB handle
1 stemhead fitting
1 "lip cleat?" (bronze bit to lead and anchor line around the forestay, starboard bow)
6 bronze horn cleats
1 in the moddle of the foredeck
2 aft of the mast
1 on the CB (this one has uneven horns to allow jamming the sheet)
2 on either stern quarter
1 pair of gudgeons on the transom
1 pair of pintles on the rudder
2 chain plates
1 forestay, 2 other stays (1/8" w/ adjuster)
2 jib tracks - replace w/ Harken 453 18" if missing
2 jib cars
2 jib blocks - replace with Ronstan 55mm ratchet
2 cam cleats for the jib sheet mounted on CB trunk
1 swivel block/cleat for main sheet (aft top of CB trunk)
1 single block for main (center boom) - replace w/ Ronstan ratchet block
1 single block w/ becket (aft end of boom)
1 traveler block
2 standup blocks for traveler (one each side of transom)
1 block for jib halyard - fixed to mast
3 aluminum horn cleats (one on boom, two on the mast)
1 bow eye to attach painter (bronze of chromed brass)
Not listed, various screws/bolts
You can look at my
personal gallery to see closeups of many of these.
Tom is correct: D&R Marine are your best source for DS-specific parts, in particular the stays, but most running rigging, things like blocks and cam cleats and rope for various lines I would source at whatever place is convenient for you, or order them by mail from
https://www.fisheriessupply.com/