by Roger » Fri Jul 16, 2004 1:15 am
I have a 1974 DS II and had to do this repair last year. Give yourself a good half day. It is quite frustrating, only because of the limited space you are working in. Here is how I did it. From the front of the boat, drill out the hole for the size of the new boweye bolt. Insert a stiff straightened out coathanger. You should be able to push it in about 18 inches before it hits the bulkhead. Now inside the cuddy, using a dremmel tool, I cut a circular hole in the bulkhead that would later fit an 4" inspection port. Draw it out first. The center of the hole would be about 6" below the top of the cuddy. Behind that is rigid foam. Laying inside the boat, head first, with a shop vac and mask on (the dust is putrid) start chiseling away a tunnel towards the suspected location of the bow eye. At first you can chisel out fairly big chunks, but once you are about 8-10 inches in, it is a bit more difficult. At one point I duct taped the chisel to the end of the shop vac hose and stabbed and pryed away. Eventually your tunnel will intercept your coat hanger, and you can then use it as a feeler guide for the rest of your tunnel. Once you get to the front, you can use a flatter chisel up against the fiberglass hull to scrape off any remaining foam. There is a metal backing plate back there that you will feel. Clean out your tunnel as best you can, and have a friend insert the boweye bolt from the front of the boat, while you apply the washer and nut, literally elbow deep from your position. It is best to put the washer on first, remove your arm, then go in with the nut and spin it on. With a long socket extension tighten up the nut. I actually had to use two socket extensions to reach the 18" in to the back of the nut.
When this is done, mount the inspection port. Don't worry about replacing the foam, you may have to go back in there again. As well, you have a nice place for your booty!