by Bob Hunkins » Thu Jul 20, 2000 12:00 am
I learned a great way to do this on my Spindrift DS (#11750), and I didn''t need a professional to help. I wish I could show you a picture, but I can't, So I'll try to describe it in words:
1. Take a 1 ft. length of track with a corresponding car, (I used 5/8" wide Schaeffer) and attach it to the combing at the forward edge of the cockpit. If you have a double hull Spindrift, you can secure the track to the combing and fiberglass beneath using nuts and bolts for the forward end of the track. For the aft end, use wood screws or sheet metal screws. I was a bit concerned about the wood screws pulling out, but so far it's been very solid. If you have a single hull, it will be easier - use nuts and bolts all the way.
2. To the car attach a swivel mounted block.
3. On the underside of the cuddy, no more than 1 foot forward of the aft edge and as far outboard as you can place it , attach another swivel mounted block.
4. Take your jib cleat, remove it from the top of the cuddy and turn it upside down. Re-attach to the underside of the cuddy using the existing holes. You may need to use shorter bolts, and it would be a nice touch to cover the exposed ends of the bolts with acorn nuts.
5. When you rig the jib sheet, it will first run from the clew of the jib to the block on the track, then forward to the block on the underside of the cuddy, then to the cleat. It will have a sort of zig-zag path to it.
6. Do the same thing for the other side.
Notes:
If you have inhaulers (a.k.a. barberhaulers) you will run the sheet through the inhauler before you reeve it through the blocks.
If you have a spinnaker launched from a turtle (aka laundry basket, 5 gallon bucket etc.), make sure the spinnaker sheets and halyard are placed on top and inboard of the jib sheets.
I changed over to this system from the old cuddy top in mid May. Since then, I've seen a noticable increase in speed, especially while reaching. My crew likes it a lot more because the angle that the cleats now have make it much easier for her to release the sheet. It also gets more rigging out of the wind. It uses the existing jib cleats and their boltholes, so I don't need to fill them.
I didn't come up with this system myself, so I'll give credit where it's due: Manuel LaBlanc, Andy Katz and Kevin Clark of Arlington, TX fleet 64 showed me this system. Thanks to them!
-Fair winds & following seas,
Bob Hunkins
Fleet 25, Houston, TX
DS #11750 "Surprise"