Its been about a year now that I've been fiddling around with rigging my DS-I with a spinnaker, but now I am finally ready to start drilling holes.
Due to the configuration on my cockpit, I will need to cleat off the spinnaker sheets on the rail. (my seats are enclosed so there is no way to run the sheets under the rail.
I plan on installing a standing block in the stern that will feed a check block and cam cleat mounted on the rail facing the center of the cockpit.
At about what location should I install the check block/ cam cleat ?
I was thinking that while sailing downwind, the helms person would be sitting more towards the rear of the cockpit. So perhaps the spinnaker sheet cam clear should be at the mid point of the cockpit ?
Thanks
Bill H