Transom Cutout

Regarding the DS3 only. Note that the DS3 is not a class-legal Day Sailer.

Moderator: GreenLake

Transom Cutout

Postby DS1976 » Wed Jul 11, 2018 12:23 pm

I have a new (to me) DS III. As you can see in the photo below, it has a cutout in the transom for a motor. I haven't seen this in any other photo of a Daysailer of any series. Was it standard on the DS III at any time, or is this the work of a prior owner? It's annoying, because the sides of the cutout prevent the motor from spinning 180 degrees given that there isn't enough clearance for the controls on the front of the engine.
Attachments
D6F13654-E141-4600-A23D-45ED752D538E.jpeg
D6F13654-E141-4600-A23D-45ED752D538E.jpeg (46.67 KiB) Viewed 2361 times
DS1976
 
Posts: 3
Joined: Mon Apr 16, 2018 5:46 pm

Re: Transom Cutout

Postby GreenLake » Thu Jul 12, 2018 3:19 am

Your suspicion that this is not original is most likely correct.

The reason will be that the shaft for your motor was too short (or if motor and boat are not from the same purchase, someone owned one with a short shaft).

You can always try to trade the motor for one with a longer shaft and reverse the modification.

One advantage of having the motor low is that it's out of the way of sheets, etc. but your DS seems to have center-boom sheeting, so that's not an issue.
~ green ~ lake ~ ~
GreenLake
 
Posts: 5735
Joined: Mon Jun 18, 2007 3:54 am


Return to Day Sailer III Only

Who is online

Users browsing this forum: No registered users and 2 guests