by GreenLake » Mon Jun 21, 2010 8:19 pm
I don't own more than one trailer, so I can't base my input on a true comparison. However, the trailer as shown
[thumb=839]
[click on image to enlarge]
works reasonably well. The bunks extend a bit behind the frame, so not much of the boat is unsupported. As this isn't a motorboat with a heavy outboard hanging from the transom, I don't think the transom needs to be supported.
Each cross member of the trailer frame has a roller. on sits nicely underneath the centerboard, supporting it.
I moved the winchpost forward so that I would get what felt to me a decent tongue weight. Note that when balanced just so, the trailer wheels end up a or slightly behind the thwarts.
On my favorite ramp, the trailer hubs don't need to be immersed for launching, but I've never figured out a way to retrieve the DS without putting the rear roller just below the water's surface, which means immersing the hubs. (By using Bearing Buddies I've been able to limit the damage to the hubs, even with saltwater launches, but I'll have to replace the springs before soon).
I changed the rear roller to one with a sharp groove at some point. That centers the bow, giving me time to straighten out the boat. All I need to do is keep the boat straight from then on.
This trailer has a break-back feature, that is you can tilt frame, bunks and rollers while the tongue stays flat, creating a steeper angle. That often helps in launching, but I've never been able to make that work in reverse, because the bow is so vertical that it catches at the next roller instead of gliding up.
~ green ~ lake ~ ~