cutting javelin mast for tabernacle
Moderator: GreenLake
2 posts
• Page 1 of 1
cutting javelin mast for tabernacle
by adlanders » Fri Sep 04, 2009 3:42 pm
Anyone have experience/advice re: cutting the javelin mast to install the hinged tabernacle? I have the tabernacle from D and R, just a bit unsure how to do the cut with my hacksaw. Thanks, Doug
- adlanders
- Posts: 1
- Joined: Fri Sep 04, 2009 3:35 pm
by persephone » Fri Sep 04, 2009 4:42 pm
Very very carefully!
Sorry, couldn't resist. I would use a miter box to make sure the cut is perfectly straight. If you need measurements I have an old Jav mast disassembled in my basement, I could measure the under deck end if you need it.
Sorry, couldn't resist. I would use a miter box to make sure the cut is perfectly straight. If you need measurements I have an old Jav mast disassembled in my basement, I could measure the under deck end if you need it.
Geoff Plante, former DS1 owner
1950(ish) vintage National One Design.
1950(ish) vintage National One Design.
- persephone
- Posts: 127
- Joined: Sun Jun 08, 2008 9:08 pm
- Location: Merrimack Valley, MA
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 30 guests