Topics primarily or specifically about the DS2. Many topics are of general interest, so please use forum sections on Rigging, Sails, etc. where appropriate.
Moderator: GreenLake
by jbrew » Tue Aug 06, 2019 9:17 pm
My DS2 has a centerboard that is about ready to break and am planning to make a new one. My main question is what is the diameter of the centerboard bolt? I am about a thousand miles away from the boat so can't make a direct measurement of the bolt at this time. Also would appreciate any advice from others who have made or are planning to make centerboards. Am thinking to use a clear cedar or redwood core with a fiberglass sheath. Never expect to race in DS class regattas but would like the performance and strength to be good. Thanks for any input/advice.
-
jbrew
-
- Posts: 6
- Joined: Thu Apr 06, 2017 10:09 pm
by kokko » Thu Aug 08, 2019 8:02 pm
dR marine could tell you
DS1 Truelove
-
kokko
-
- Posts: 469
- Joined: Tue Mar 11, 2008 4:17 pm
- Location: St. Paul, MN
by Alan » Fri Aug 09, 2019 1:14 am
The diameter depends on the model year of the boat. Early models used a bolt. Later models (like my 1980 DSII) used a pivot pin, which is bigger in diameter than the bolt was.
Kokko's right about D&R Marine. I recommend finding out as best you can from a thousand miles away what model year your boat is, then calling Rudy at D&R.
-
Alan
-
- Posts: 756
- Joined: Wed Jun 17, 2009 4:39 pm
Return to Day Sailer II Only
Who is online
Users browsing this forum: No registered users and 14 guests