DS II Compression Post Area Cracked

Topics primarily or specifically about the DS2. Many topics are of general interest, so please use forum sections on Rigging, Sails, etc. where appropriate.

Moderator: GreenLake

Re: DS II Compression Post Area Cracked

Postby TJDSII6630 » Thu Jul 09, 2020 6:21 pm

Getting in a bit late, like a blister, after the work is done.

Here is how I fixed my mast base.

I needed additional height to get the rig tension right and discovered the wood under the base to be rotted.

Had not sagged, just rotted.

I think too much mast was cut when the step was installed on the deck thus the "long rig".

I drilled the holes shown and dug out the rotted wood and soaked the rest with resin thinned with lacquer thinner.

I packed the cavity with kitty hair bondo.

I backed the bolts out just as the bondo was firming up, applied a bit of oil and put them back in.

Note the shims I used to get the required height

Teddy
TJDSII6630
Attachments
Mast Step.JPG
Mast Step.JPG (229.95 KiB) Viewed 73 times
TJDSII6630
 
Posts: 23
Joined: Mon Aug 27, 2018 2:06 pm
Location: South Carolina

Previous

Return to Day Sailer II Only

Who is online

Users browsing this forum: No registered users and 3 guests

cron